The short answer
Drawout breakers can be swapped in minutes. Fixed breakers require a shutdown and a wrench. In practice, the answer usually comes down to three numbers: the amperage your service carries, the voltage class your utility delivers, and the fault current available at that point. Once those are fixed, the equipment selection follows.
Why it matters
Switchgear is not a commodity box. The bus bracing, breaker frame and enclosure rating are chosen for a specific fault level and a specific room. When any one of those assumptions changes — a larger transformer, a added feeder, a different utility configuration — the equipment has to be re-checked, not just re-priced.
That is also why two quotes for the "same" 2000A lineup can differ by tens of thousands of dollars. One is braced at 65kA with insulated case breakers. The other is braced at 100kA with low-voltage power breakers, drawout compartments and a full relay package.
How to apply it on your project
- Start from the utility letter: service voltage, amperage and available fault current.
- Confirm whether the system is grounded wye or delta — it changes the pole count and the neutral.
- Decide indoor or outdoor, because the enclosure rating drives the layout.
- Check the room: section width, door swing, cable entry and working clearance.
- Get the approval drawing reviewed by the installing electrician before fabrication.
Common mistakes
The three we see most often: quoting from an old single-line that no longer matches the service, forgetting utility metering in the section count, and assuming a standard lead time during a busy construction cycle. Each one costs a week or more if it surfaces after the drawings are approved.
Related reading
- Why Switchgear Lead Times Stretch in a Busy Market
- What a Utility Fault Study Tells a Switchgear Builder
- Five Things Contractors Forget on a Switchgear Submittal
- How a Virginia Plant Replaced a 1970s Lineup in One Weekend
- What Data Center Growth Means for 480V Distribution
- Switchgear in Flood Zones: What Changes